Parabody Leg Press 5 Uživatelský manuál

LP5 LEG PRESS 5CLASS HPART# 7357701REV. BVersion: LP5A-101Revision: 11/08/021ASSEMBLY INSTRUCTIONSWARNING:Read and follow all directionsfor each step

10STEP 6:FIGURE 6• CAREFULLEY slide the SEAT ADJUST (2) into the FRAME (1) as shown. The SEAT can be adjusted by turning the SPRING PINKNOB (14) clo

STEP 7:FIGURE 7• SECURELY assemble one PAD (8) to the SEAT ADJUST (2) using two 3/8 X 3” BOLTS (9) and two 3/8” FLAT WASHERS (10) asshown in FIGURE

12STEP 8:FIGURE 8• SECURELY assemble one PAD (8) to the FRAME (1) using two 3/8 X 3” BOLTS (9) and two 3/8” FLAT WASHERS (10) as shown inFIGURE 8.

MAINTENANCEMODEL #________________________SERIAL #_________________________DATE OF PURCHASE: _____________DEALERS NAME: _________________DEALERS PHONE

14NOTES:LIMITED WARRANTYParaBody extends the following LIMITED WARRANTY to the original owner of the ParaBody products. The Warranty terms apply to IN

INTERNATIONAL OFFICESLife FitnessAtlantic BVAtlantic HeadquartersBijdorpplein 25-312992 LB BarendrechtThe NetherlandsPhone: (180) 646 666Fax: (180) 6

THERE IS A RISK ASSUMED BY INDIVIDUALS WHO USE THIS TYPE OFEQUIPMENT. TO MINIMIZE RISK FOLLOW THESE RULES!1. Before using, read all the warnings and

Tools Required for Assembly* 3/4” wrench* 9/16” wrench* Ratchet with 3/4” and 9/16” sockets* Adjustable wrench* Tape measure3NOTE: BOLT LENGTH IS MEAS

4PARTS LISTPART #ACU04-1444ACU04-1447ACU04-1449ACU04-1445ACU04-1446ACU04-1448ACU02-1298ACU07-0135ACUDA1E03830016NBKEY123456789QTY111111126PART #ACUDC1

9−1/2"5FIGURE 1STEP 1:• SECURELY assemble the SECOND ARM (5) to the FRAME (1) using one 1/2 X 4-3/4” BOLT (12), one 3/4 X 4” SHAFT (15) an

11−1/4"6FIGURE 2STEP 2:• SECURELY assemble the SECOND ARM (5) to the FRAME (1) using one 1/2 X 4-3/4” BOLT (12), one 3/4 X 4” SHAFT (15) and on

FIGURE 3STEP 3:7• Insert one 3/4 X 4” SHAFT (15) thru pre-installed FLANGE BEARINGS in the SECOND ARM (5) as shown in FIGURE 3.• Insert one 3/4

8STEP 4:FIGURE 4• SECURELY assemble the FOOTPLATE (6) to the SECOND ARM (5) and the MAIN ARM (4) using two 1/2 X 4-3/4” BOLTS (12) and two1/2” LOCK

9STEP 5:FIGURE 5 3/8 X 3” 9 11110 3• SECURELY assemble the HANDLE (3) to the FRAME (1) using two 3/8 X 3” BOLTS (9), four 3/8” FLAT WASHER